You can download the Cisco Secure ACS 5.8 ISO image from ġ. Downloading the Cisco Secure ACS 5.8 ISO Image You can also see the Cisco UCS C-Series Rack Server guides for more information on Cisco SNS-3415 or Cisco SNS-3495 appliance. You can use the Cisco UCS Server Configuration Utility, Release 3.0 User Guide to configure theĬisco SNS-3415 or Cisco SNS-3495 appliance. The setup can be done by using the appliance console or CIMC. Run the setup command at the CLI prompt to configure the initial settings for the ACS server. Power up the Cisco SNS-3415 or Cisco SNS-3495 appliance to the network and appliance console. See Connecting and Powering On the Cisco SNS-3415/3495 Applianceħ. Power up the Cisco SNS-3415 or Cisco SNS-3495 appliance. Connect the Cisco SNS-3415 or Cisco SNS-3495 to the network and appliance console.
Read the general precautions and safety warnings in Preparing to Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware AppliancesĤ. Read Introducing the Cisco SNS-3415 and Cisco SNS-3495 Hardware Appliances.ģ. See Unpacking and Inspecting the ServerĢ. This section gives you an overview of the installation process and the tasks that you must perform before installing ACS.īefore you begin installing ACS 5.8, you must:ġ. The Cisco SNS-3415 or Cisco SNS-3495 appliance is preinstalled with the ACS 5.8 software. ■ Reimaging the Cisco SNS-3415/3495 Appliance Installing ACS on the Cisco SNS-3415 or 3495 Appliance ■ Downloading the Cisco Secure ACS 5.8 ISO Image ■ Installing ACS on the Cisco SNS-3415 or 3495 Appliance
This chapter describes how to install and initially configure the Cisco SNS-3415 or Cisco SNS-3495 and the ACS 5.8 server. Installing and Configuring the Secure Access Control System with the Cisco SNS-3415 and Cisco SNS-3495